A Networker Blog.-

Sending a test email…

———- Forwarded message ———-
From: Victor Cappuccio <vcappuccio@gmail.com>
Date: Sun, Jun 14, 2009 at 9:16 PM
Subject: Re: ethertypes on doccd?
To: Wouter Prins <wp@null0.nl>
Cc: Cisco certification <ccielab@groupstudy.com>

Hello Wouter!!
I am not sure if this helps, since the doccd, is not the same, as like in old days
but here it goes..

IOS ->12.3 Family –>12.3 Mainline —> Command reference —-> Bridging and IBM network Vol 1 of 2 —-> Appedex.

Cisco IOS Bridging and IBM Networking Command Reference, Volume 1 of 2: Bridging, Release 12.3
Appendix: Ethernet Type Code

http://www.cisco.com/en/US/docs/ios/12_3/ibm1/command/reference/ib1_ethc.html

On Sun, Jun 14, 2009 at 8:55 PM, Wouter Prins <wp@null0.nl> wrote:

hi all,

I searched the archives for a link to the doccd that will show me the
different ethertypes for protocols like: pvst(+), mst, ipx and ipv6. I know
ip and ip arp without any references.
Is there a way to issue a debug command to find out the ethertype values of
a particular protocol? I want to avoid learning hex numbers and forget about
them eventually.

Tnx.
–
Wouter Prins

Blogs and organic groups at http://www.ccie.net

_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html